This command will set the fog state of the specified object.

SET OBJECT FOG Object Number, Flag

Object Number

Integer
The object number

Flag

Integer
Setting the fog to one will ensure the object is affected by the global fog level

This command does not return a value.

Setting the fog to one will ensure the object is affected by the global fog level.

sync on : sync rate 60 : hide mouse:cls 0:color backdrop 0

fog on:fog color 0:set ambient light 50

ObjectNumber=2:ImageNumber=2

wire=0:trans=0:cull=0:fliter=0:light=0:fog=0:ambient=0

set global object creation 0

set dir "models"

load object "ast4.x",ObjectNumber

set object specular ObjectNumber,0

rotate object ObjectNumber,270,0,0

set dir ".."

while mouseclick()<>2

set cursor 0,0

print "press 1 to set object wireframe";wire:if inkey$()="1" then wire=1-wire:set object wireframe ObjectNumber,wire

print "press 2 to set object transparency";trans:if inkey$()="2" then trans=1-trans:set object transparency ObjectNumber,trans

print "press 3 to set object cull";cull:if inkey$()="3" then cull=1-cull:set object cull ObjectNumber,cull

print "press 4 to set object filter";filter:if inkey$()="4" then filter=1-filter:set object filter ObjectNumber,filter

print "press 5 to set object light";light:if inkey$()="5" then light=1-light:set object light ObjectNumber,light

print "press 6 to set object fog";fog:if inkey$()="6" then fog=1-fog:set object fog ObjectNumber,fog

print "press 7 to set object ambient";ambient:if inkey$()="7" then ambient=1-ambient:set object ambient ObjectNumber,ambient

while scancode()<>0:endwhile

if mouseclick()=1 then yrotate object ObjectNumber,wrapvalue(object angle y(ObjectNumber)+1)

sync

endwhile

while mouseclick()=1:endwhile

delete object ObjectNumber

end

BASIC3D Commands Menu
Index